服务支持 技术支持 下载中心 客户留言   服务支持 技术支持 ●应用文献 AN-05 User Defined CPIB drivers for the CCMT System AN-06 Load Pull Measurements on Very Low Impedance Transistors AN-08 Basics on Load Pull and Noise Measurements AN-09 Power Efficiency Measurements using the CCMT AN-11 Load Pull Measurements on Transistors with Harmonic Impedance Control AN-12 AM/PM Distortion Load Pull of Power Transistors AN-14 On-Wafer Load Pull and Noise Measurements using Computer Controlled Microwave Tuners AN-15 High Resolution Tuners Eliminate Load Pull Performance Errors AN-18 Accuracy and Verification of Load Pull Measurements AN-19 On-Wafer Noise Parameter Measurements using Cold Noise Source and Automatic Receiver Calibration AN-22 Peak Search Algorithms of CCMT Software AN-23 Selective Load Pull using Pattern and Section Tuning AN-24 Concept for Load Pull Measurements with Harmonic Impedance Control AN-25 High Reflection Load Pull: Possibilities and Tradeoffs AN-26 Create Your own Load Pull tests using MATLAB-TUNE AN-28 Macro File Operation of the CCMT System AN-31 Accurate Noise Parameter Measurements Using a Spectrum Analyzer as Noise Receiver AN-33 Harmonic Tuning Isolation in Load Pull Setups using PHT AN-42 Using Stub Tuners and Slide Screw Tuners AN-44 Nonlinear Transistor Testing using Highly Accurate Harmonic Load Pull Tuners AN-45 Algorithm for Automatic High Precision Residual Tuning to 50 W using Programmable Tuners AN-46 Mechanical Vibrations of CCMT Tuners used in On-Wafer Load Pull Testing AN-48 On Wafer Load Pull Tuner Setup: A Design Help AN-49 Comparing Tuner Repeatability AN-50 Upgrade ATS Load Pull Systems using Focus ULPS Soft- and Hardware AN-52 Tuner Control and Load Pull Using GPIB and Dynamic Data Exchange (DDE) AN-54 Spurious Oscillations during Load Pull AN-55 On Wafer Load Pull of Sub-Ohmic Power Chips AN-56 Harmonic Effects in Load Pull using Wideband Tuners AN-57 iTuners for Production Testing AN-59 The Effects of Harmonic Tuning on EVM AN-60 High-Power Load Pull at 40 MHz using Low Frequency Tuners (LFT)   ●产品文献 PN-31 Probe Holder for On Wafer operation of 33 to 110 GHz Waveguide Tuners PN-32 RF Switch Control Box for automatic Noise and Load Pull measurement setups PN-33 ALPS, Active Load Pull System for PCN Application PN-34 LSM, Large Signal S-Parameter Module PN-35 WinGraph, Load Pull Contouring Software for Windows PN-36 WinPlot, Cartesian and Polar Plot Generation Software for Windows PN-41 Computer Controlled Microwave Tuner System – CCMT PN-44 Programmable Harmonic Tuner, PHT PN-45 Manual Microwave Tuners, model MMT PN-46 Programmable “Combo” Load Pull Tuners For Fundamental and Harmonic Tuning PN-47 Integrated Load Pull System, ILPS PN-50 Long and Short Term Tuner Accuracy and Calibration Repeatability PN-52 Prematching Tuners for Very High VSWR and Power Load Pull Measurements PN-53 3-Axis Wafer Micro-Positioners for CCMT Tuners PN-54 MLTF, a Minimum Loss Transistor Test Fixture for Sub 1W Load Pull Measurements PN-55 Programmable Millimeterwave Tuner CCMT-5010-H (10-50 GHz) with Harmonic Tuning to 60 GHz PN-56 WinPads, a Power Amplifier Design Software using Load Pull Contours PN-58 Manual Prematching Modules, MPM for Frequencies between 0.8 and 50 GHz PN-59 High Power 0.2 – 6 GHz Tuner using 7/16 Connectors PN-60 0.05 to 7 GHz TRL VNA Calibration Kit with 7/16 Connectors PN-61 0.5 to 50 GHz TRL VNA Calibration Kit with 2.4mm Connectors PN-62 0.04 to 12 GHz TRL VNA Calibration Kit with Precision N-Connector PN-63 0.05 to 18 GHz TRL VNA Calibration Kit with Precision 7mm (APC-7) Connectors PN-64 0.3 to 40 GHz TRL VNA Calibration Kit with 2.92mm (K?) Connectors PN-65 0.3 to 27 GHz TRL VNA Calibration Kit with Precision 3.5mm Connectors PN-67 Millimeterwave Manual and Harmonic Tuners with Prematching Capability PN-68 High Isolation Manual Harmonic Tuner, Model MHMT-308-2H/3H PN-69 Manual Fundamental and Harmonic (‘Combo’) Tuner, Model MHMT-308-2H/3H PN-70 MLTF, Minimum Loss Test Fixture for Package De-Embedded Load Pull Testing PN-71 PCI Controller Interface for Focus Programmable Tuners PN-72 CCMT-SP Synchronized Prematching Tuners PN-73 Vibration Tester for On-Wafer Tuner Operation PN-74 10 to 50 GHz Programmable Tuners with Prematching Module for on-wafer measurements PN-75 DLPS, a Differential Load Pull System PN-77 DataView, ContourViewer and WinPlot: Focus Microwaves Graphics Software PN-79 MPT, a Multi-Purpose, Vibration-Free Tuner PN-80 iConverter, Upgrading electro-mechanical Tuners to iTuners PN-81 iCCMT-18100-IBL, A High Reflection, Low Insertion Loss Solution for On-Wafer Load Pull at 10-18 GHz PN-82 VSWR++ iTuner Calibration Routine for highly constant VSWR testing PN-83 WLAN/WiMAX Load Pull Solutions   ●技术文献 TN-198 Harmonic Load Pull Upgrade For Focus Microwaves CCMT Systems TN-298 Harmonic Load Pull System Upgrade For Maury Microwave ATS Load Pull Systems TN-398 Upgrade the ATS Load Pull System using FOCUS “WinPower” Software TN-2000 Brief Comparison of Harmonic Load Pull Systems TN-47 Effect of Driver Amplifier Harmonics on Load Pull Measurement Accuracy and Linearity

Copyright © 2008 深圳市易商仪器有限公司 All rights reserved. 地址：深圳市福田区福虹路9号世贸广场C1207~1208 邮编：510083 电话：0755-83005181/2/3 传真：0755-83005184